Need to cut clean, precise internal M20 threads with a 2.5mm pitch? This 2-pack of straight flute taps from sourcing map is a solid choice for workshop use. Made from high-speed steel (HSS 6542), they're hard, tough, and resist wear, making them suitable for tapping materials like mild steel, alloy steel, stainless steel (use tapping oil!), cast iron, copper, and more. The straight flute design is best for through-holes or shallow blind holes, as it allows chips to push straight down and out of the hole. Each tap has a total length of 110mm with a 39mm long threaded section and an 11mm square drive shank for use in a tap wrench, drill press, or milling machine. They have an H2 accuracy grade for a good, standard fit. Important: These are machine taps. They are NOT recommended for use with a hand-held electric drill – use a proper tapping machine or a drill press at low speed for best results and to avoid breaking the tap. Always drill the correct pilot hole first! A reliable, affordable set for creating or repairing threads.